BEARING BUDDY #1980, WHEEL BEARING PROTECTORS 1.98%u201D (Chrome).

Description

Model No. 1980 Chrome plated. For use with 1.980 inches (50.29 mm) hub bore, Outer Bearing Cone: L-44643, L-44649, L-44640, Outer Bearing Cup (race): L44610 Why Trailers Need Bearing Protection Boat Trailer Trailering, even a short distance, heats the hubs. When the wheels are submerged during launching, the hubs suddenly cool and the air inside the unprotected hubs contracts, forming a vacuum which draws in water through the rear seals. There is no such thing as a rotating seal that stays perfect. Water and grit thus drawn into the hubs relentlessly destroy bearings. When properly installed and maintained, Bearing Buddy® prevents wheel bearing failure and eliminates bearing repacking. Boat trailer wheels can be completely submerged. Utility Equipment, ATV, Horse, Camping, and other occasional use trailers These trailers, because they are not used regularly, are also subject to bearing corrosion and failure from condensation moisture from air sucked into hot hubs as they cool. Moisture stays in the hubs causing rust and pitting until they are reheated when the trailer is used again. How Genuine Bearing Buddy® Works The axle hub is filled with grease until the grease forces the Bearing Buddy® piston outward about 1/8 inch. Because the piston is spring loaded, the piston exerts a slight (3 PSI) pressure against the grease, which maintains a slight pressure between the inside of the hub and the outside environment. When the hub is submerged, water cannot enter the hub because of this pressure. An automatic pressure relief feature prevents over-filling and over pressurization. See Bearing Buddy diagram: Without this feature, the inner seal will be damaged. Grease can be added to the hub through an easily accessible grease fitting located in the center of the piston. Lubricant level (and pressure) can be checked quickly by pressing on the edge of the moveable piston. If you can rock or move the piston, the hub is properly filled. In addition to packing the bearings in the traditional manner, it's best to get as much grease as possible inside the hub cavity between the bearings and then, while the Bearing Buddy® is off, fill it with grease as well from the backside. The air pockets inside the hub cavity and Bearing Buddy® will work their way out past the piston (or blue ring) on the Bearing Buddy®. | Model No. 1980 | Chrome plated. For use with 1.980 inches (50.29 mm) hub bore, | Outer Bearing Cone: L-44643, L-44649, L-44640, | Outer Bearing Cup (race): L44610